Hi,
I'm attempting to update my CIC to version C1A, but I'm encountering Error 106. Here’s what I’ve tried so far:
- Imported SP data using BMW coding tool (selected SP source -> Update SP-data -> chose WINKFP update).
- Verified the files in the Ediabas\ecu folder to ensure they are correct.
I’m updating via both bmw icom next and ICOM B (OBD and MOST ports are connected). On the ICOM B, both SYSTEM and MOST LEDs are green. I’ve used Easy Connect with the following settings:
- TYPE: REMOTE
- IP: The ICOM IP is shown in Itoolradar
- MODE: MOST_ASYNC
I selected ICOM Lock and clicked Check; no errors appeared during this process.
I’m not sure why I’m encountering this error. Any help would be greatly appreciated.
Thanks!
I'm attempting to update my CIC to version C1A, but I'm encountering Error 106. Here’s what I’ve tried so far:
- Imported SP data using BMW coding tool (selected SP source -> Update SP-data -> chose WINKFP update).
- Verified the files in the Ediabas\ecu folder to ensure they are correct.
I’m updating via both bmw icom next and ICOM B (OBD and MOST ports are connected). On the ICOM B, both SYSTEM and MOST LEDs are green. I’ve used Easy Connect with the following settings:
- TYPE: REMOTE
- IP: The ICOM IP is shown in Itoolradar
- MODE: MOST_ASYNC
I selected ICOM Lock and clicked Check; no errors appeared during this process.
I’m not sure why I’m encountering this error. Any help would be greatly appreciated.
Thanks!